...ribbon cassette (see Changing The Ribbon Cassette) and remove the two spools of the lift off tape by pulling them outwards. 3) Place the empty spool of new tape on the left pin so that the tape winds ...
Question about Office Equipment & Supplies
...ribbon cassette from IBM Selectric II. Would like to place it in another Selectric II that runs well but has no ribbon. I pulled the lever on the right but the right side of the cassette stays put. ...
Question about Brother Office Equipment & Supplies
ribbon cassette but ribbon won't advance when I start typing. Thought I might have a defective ribbon cassette so I put in another one and same problem. Any suggestions? I've had this typewriter since
Question about Smith Corona Office Equipment & Supplies
...Ribbon Cassette 1) Move the print carrier to the center of the platen using the SPACE or BS key. 2) Hold the ribbon cassette on both sides and lift up the front portion (where the ribbon is exposed) ...
Question about Nakajima Office Equipment & Supplies
...ribbon is fully down and latched, also be sure the L/O tape is not sitting to high and stealing the underscore. DickyO We have had new cassettes that are faulty. The quickest way to test is to change ...
...wheelwriter 3? The correction cassette snaps on the bottom of the ribbon. The two little "feet" on the cassette slide over the small tabs on the ribbon and the ribbon clips on. Hope this helps ...
ribbon replace on ibm selectra 2 how do you replace type writer ribbon on a ibm selectra 2 Lift top cover up. Move the carrier to center of machine. On the right hand side of the carrier there is a ...
Question about Nakajima Office Equipment & Supplies
...ribbon cassette base on the RHS there is access to a small "phillips head" screw. Remove the ribbon cassette, move the carriage to the LHS,POWER OFF. Loosen the screw, do not remove it or you will ...
...cassette upwards. Then replace with the new ribbon and close the flap. The menu will prompt you to tell the printer that the cassette has been replaced. Hi there, Are you still looking for this ? We ...
Question about Swintec Office Equipment & Supplies
...of the cassette to the front, remove old ribbon, wind new ribbon until slack is gone, put the ribbon behind the 2 black ribbon lifters, snap ribbon into place, move red lever back home, done. ...
179 questions posted
Usually answered in minutes!
1,135 Questions
1,072 Questions
1,012 Questions
767 Questions
733 Questions