...lower stitches are too loose and when I put the higher number in the tension control the upper stitches are too tight. I tried all the types of needles cleaned the area under bobbin case and checked ...
Question about Janome Sewing Machines
...lower your presser foot, and begin sewing. Release the thread tails after a few stitches. Hope this helps. Those nasty "thread nests" are a real pain. Rather than sewing 5 stitches in place, you can ...
Question about Elna Sewing Machines
...stitch of length 2.5 and width of zero. Place fabric under presser foot and "LOWER the presser foot, its easy to forget this. No tension if you don't lower the presser foot. now sew out - FMQ is a ...
...lower looper- then upper looper- right needle- then left needle) was careful to pull all threads to the back and under the presser foot for about 6 inches. Held on to the thread, lowered presser foot ...
...stitch former from the lower knife base. (Don't lose it!)Turn the stitch with adjusting dial until the "M" on the dial matches the red indicator on the needle plate.Set the stitch width length to ...
...lower looper tighten up to 6-7 and test stitch. You want the upper looper thread to go right underneath and the lower looper thread to disappear against the needle stitch. And the fabric to roll ...
Question about Husqvarna Sewing Machines
...lenght Lower: Stitch width Using the upper left dial select the straight stitch picture Using the upper right, choose your stitch lenght Using the lower, choose your needle position, ...
Question about PfaFF Sewing Machines
YOU WERE LIKELY MOVING YOUR NUMBER HIGHER. AFTER YOU GOT TO A CERTAIN NUMBER IT NO LONGER QUALIFIES AS A BASTING STITCH BUT A STRAIGHT STITCH. USE A LOWER NUMBER AND IT WILL LIKELY TO STOP THE BEEPING
...lower stitch doesn't get pulled up to loop around the top stitch. If I keep going it will start to stitch correctly, but then stop again. The last time I used my machine it worked fine, I am ...
Question about Sewing Machines
lower stitch looks correct and not bunching, you will need to change the tension on the upper stitch. Make sure that your threads are firmly inserted within the discs also before adjusting the tension
915 questions posted
Usually answered in minutes!
337 Questions
294 Questions
223 Questions
181 Questions
150 Questions