Necchi 4595 Mechanical Sewing Machine "thread gets balled bobbin" Questions

...bobbin thread (about 3 inches). Hold upper thread tail in left hand, turn handwheel toward you for 1 revolution. Is the bobbin thread caught by the top thread and pulled through the opening of the ...

...thread to ball up The bobbin case gets stuck under something on the right side and gets very loose and gets stuck usually thats a tension problem. possibly you have some thread jammed around the ...

...bobbin thread is smoothly wound onto the bobbin and that the bobbin is inserted and thread properly in the machine. ALWAYS RAISE the presser foot and rethread the upper thread. Check that the thread ...

...thread gets all balled up on top of the bobbin instead of filling it. What should I do? Consult your owner's manual. Chances are you may be threading the thread incorrectly. Make sure it is going ...

...thread balled up and I had to remove the needle, the foot and cut threads to remove the bobbin case. one thread is still caught in area the bobbin case goes in. I can't move the needle up and ...

...thread gets balled and needle can't move Lint and or thread has collected behind or under the bobbin. use a q-tip (cotton) and swipe out and around the bobbin and bobbin case. Use a can of air and ...

...around the bobbin winder thread guide once for more tension and then thread it normally. If you do this, lower the tension to 5, test sew and then tighten the tension until the loops go away. ...

...bobbin thread until you have taken a few stitches, this will prevent nesting and jamming. I don't have a machine like yours, but am giving you what I have learned over the years from the many, many ...

...bobbin thread from jamming up everytime Can't get the machine to go as it keeps jamming up with the bobbin thread that keeps balling up There are a couple of reasons that can cause this. a. Raise the ...

...thread gets entangled with bobbin and the machine jams fast and the needle breaks. try adjusting the needle thread right up to stop the bunching of thread that is causing the problem Install a brand ...