GE WJSR2070B Top Load Washer "lid swith" Questions

...lid is shut, for safety reasons wont run, can you hear any "click" just before the lid actually closes, it should be triggering the lid swith, if no t reppalce the lid switch assy, reall common ...

...the lid swith you will half to lift your consol and remove the clips & disconect the lid switch connector holding the front cab in place and remove the cab to properly replace the lid

...lid control swith was broken. Replaced switch and now the safety switch wont release the lid after the cycle is done for 2minutes then you can open lid Answered (hopefully) on your other posting ;-0) ...

...swith to the rinse or spin cycle to pump the water from the unit. What do you suggest I do to get it working again? It may be it the Lid switch... bad lids swithes will stop washers from going into ...

...SETTING TO PUMP OUT AND WOULD NOT WORK. SOUND LIKE THE LID SWITH YOU CAN BYPASS UNDER THE CONSOL 2 PLUG 1 IS POWER THE 2ND IS YOUR LID SWITH SPLICE WIRES LEAVE THE GREEN WIRE PLUG BACK ...

lid swith maytag washing machine. how do you replace the lid swith on my washing machine Open the top of the unit by placing a putty knife beween the top and the front panel about two inches in. There

...lid swith is bad, it will fill and agitate, but will not pump or spin. therefore it will not go into rinse cycle without being able to pump out water. some lid swithes control the agitation also ...

it gets turned on it sounds like it starts to sense the load, the lid lock light comes on, then it stops sen Replaced the water inlet valves and lid lock swith My first thought would be Shift Actuator

My washer fills with water and then doesn't start. If I slam the lid down a couple of times, it usually starts. Not now. Any suggestions? you need to by pass lid swith under top console

...lid closes ... I have to push the ''swith'' my selft with a screwdrive or my finger ... ??? did something plastic break off the lid that depresses this switch ??? or what else could it be? THANKS ...