GE WSM2780W Stacked Washer / Dryer "picture tube removal" Questions

...picture of the drive block, I hope if it downloads. The spin tube locks into this drive block with two tabs that fit in respective grooves in the block. If the tabs are worn off the spin tube, that ...

...picture Im attaching. This is where your problem probably exists. As long as you don't have something caught in between the tub and the basket and your drive block is ok, it's either the clutch assy. ...

...this far there is probably a piece of calcium or rubber holding a valve open. I would have to see pictures to further diagnose any

...picture for me. Here's how I fixed the leaking washer. Sitting in front of the washer I removed two small screws on the bottom left and right of the front panel. Then sliding the front panel DOWN, it ...

...picture so you can identify it. This error can be generated from a faulty pressure switch. You will have to remove the top cover from the washer. It is held on by screws at the back. After removing ...

...picture guide of where the metal band goes so I can put the seal back in. you will have to take off the front off washer to put it back correctly. remove the top panel 3 screws in top rear remove the ...

...picture for me. Here's how I fixed the leaking washer. Sitting in front of the washer I removed two small screws on the bottom left and right of the front panel. Then sliding the front panel DOWN, it ...

The adapter gizmo included a valve so I could control the water flow and not give myself a bath. A picture of the gizmo is included below. Make sure that when you connect the water hose to the faucet

...picture as different washers have different shaped trays!) It works by siphoning the water+softener over the lip of the pipe/tube (not 'line', sorry) under its cover then out of the bottom of ...

...down remove . remove inner tub Nut center tube should lift up and out. next step if your changing shaft is all from bottom. lot more down there. Take picture b4 and as you remove for ref. to ...