main rollerbearing of tub is no good and cannot buy just bearing but also tub etc.what todo? is there a recall on this model Here you go: Plan B: NOTE: Every production run I don't know from. Here are
main power off and unplug the machine from the wall. 3. Completely remove the powder dispenser drawer. There is a small button at the rear of the dispenser which you need to depress to remove it fully
...rear drum bearing is making a loud during the spin cycle, in turning the drum by hand i don't feel any play in the bearing, however the bearing feels rough and will not last long, i looked up the ...
...main power off and unplug the machine from the wall. 3. Completely remove the powder dispenser drawer (it will come out so far (and stop), then there is a small button at the rear of the dispenser ...
main or shutoff valve and unscrew the supply hoses from the back of the machine with an adjustable pliers. Pry out the old hose washers with a flat-blade screwdriver. Install new gaskets in both hoses
...MAIN BOARD (see below instructions). If good... Inspect the wiring at the motor--remove the rear service access panel. Remove the 17mm bolt at the center of the rotor--this can be tight as ...
Question about Frigidaire Washing Machines
...rear. I have four young boys, and do laundry constantly, and the occasional cleaning with bleach just doesn't keep up. Before I know it, I get loads out of the dryer that reek (you can't always tell ...
...rear tub water seal??? if so, is there an instructional video online (I have looked but can't find) It took me about 6 hours to change the boot seal (the clamps were the main problem) No specialised ...
...rear main drum bearing starting to go bad. The seal goes bad first and the packing grease will start to weep out as water gets into the bearings. Is the washer starting to get loud during any spin ...
1,215 questions posted
Usually answered in minutes!
992 Questions
371 Questions
398 Questions
323 Questions
255 Questions