GE J2B915SS Dual Fuel (Electric and Gas) Kitchen Range "test switch stove top" Questions

...switch the lower oven sensor with the upper to confirm that it is bad? I had the same problem, same symptoms... You probably need to replace the baking igniter, (Igniter,bake burner Part Number: ...

...stove top is warm stays on all the time. This is usually the infinite switch has failed. They are easy to check and inexpensive. Here is a video that will walk you thru testing an infinite switch. It ...

...stove. yes you can goto appliancepartspros.com type in your model number under the section top you will find your part number... when it arrives unplug the unit and remove the screws holding the top ...

switch has gone bad causing the light to be on when off,it could be anyone of the 4 since the light will come on no matter which one is turned on. To test and see which one it is..remove back panel so

...switch to the elements. If you have an electrical test meter, this will be no problem for you to check. If not, they will usually test them for you for free at an appliance parts supply house (and of ...

switch below. On some flat top models, you need to open or take off the over door before you can lift the top. Most stove tops will then lift off, but you may need to take off a screw or two. Also, on

...and measured 15 ohms across the terminals. Think it is okay. Haven't tested broil yet. Have the wiring diagram that came with stove. Any suggestions? Possibly the control switch or t/stat Good ...

...switch is also possible. Kill power to the range and test the heating elements for continuity with resistance meter or multimeter. For the lower baking element: Again, check for blown fuses in the ...

...which is either the burner or the switch that controls the burner. A voltage test would have to be done to determine which compoonent has failed. Generaally it is worthwhile to repair the

...switch. the element is new so . i don't want to pay another service charge to have someone come out and test the element etc. as i have ohmmeter etc and can do that, i just don't have a wiring ...