Question about Kymco Venox 250 Motorcycles
...cylinder for a 2007 kymco venox 250cc it broke the rocker arm in it... & not really sure why or what caused it, if I replace the head, will it just go out again due to another problem? Bike only has ...
Question about Motorcycles
...cylinder head do I need to replace the whole head or just buy a top end kit I have a 2001 Yamaha blaster 4 wheeler The piston wont seize into the cylinder head it will seize into the cylinder and you ...
...cap is all chipped up gotta replace that too now.should i need to replace anything else? Why can't you just polish the inside of the cylinder head a bit? You should replace the cylinder head
...Replace the cylinder studs in the cases as Harley has come out with a better stud since this engine left the factory. Replace all the gaskets and torque the heads as described in the service manual. ...
...cylinder head gasket has blown and not the rocker cover gasket this is at the top of the engine its rubber if it has it takes just a few 10mm bolts to undo then replace the gasket and no need to time ...
...on the cylinder and head are flat, and replace the gasket if they are good. Be sure to torque the head bolts and tighten in a criss-cross way. (Inspect the old gasket to verify where it
Question about Kymco Venox 250 Motorcycles
...cylinder head and inspect the head gasket and "O" ring seal if one is present. If the gasket is dirty and oily then replace the gasket & "O" ring. Consider lapping the valves while the head is off. ...
Question about Kymco Venox 250 Motorcycles
...left side were the cylinder meets the case.thanks for any Info. Sounds like a leaky head gasket .... think mitchy was right U've blown a head gasket. Replace it ASAP before it causes more ...
Question about Kymco Venox 250 Motorcycles
replace intake manifold gaskets and head/ cylinder gaskets. Check the crank bearings. Hold the flywheel in your hand. Lift it up and down then move it left and right. Any movement or is it rock solid?
Question about Kymco Venox 250 Motorcycles
i have a crack in my engine whats the best way to fix it? It really depends on where the crack is located. The engine is actually separated by the engine block and the cylinder head. CYLINDER HEAD - ...
5 questions posted
Usually answered in minutes!
22 Questions
16 Questions
5 Questions
1 Questions
2 Questions