...Remove the three screws above the oven door that are holding the bottom of the control panel to the oven frame. Pull the bottom of the control panel out about 1 inch and down and it will release. The ...
Question about Kenmore Kitchen Ranges
...remove the ribbon cable and clean contacts with a pencil eraser put cable back on and check to see if the error code comes back. Is there keypad response when you hit bake/broil ect..? I hope this ...
...remove the back panel of the range. Now inspect the ribbon cable for any visible defects to it. Sometimes the cable will arc across itself and cause a short. Inspect each one of the lines(wires) on ...
...ribbon cable, the suspect capacitor is surface mounted to the reverse side of the board, two plastic clips need to be released (gently) and the ribbon cable unplugged. Capacitor is likely discolored ...
...SHUT OFF THE POWER FIRST lift and fold out the control panel remove the ribbon cable and remove the four screws that hold the control board . replace control panel in reverse order. Good Luck!! ...
...or stuck or shorted keypad. Have someone remove the key pad ribbon cable from the control board and clean the ends with an eraser. If that doesn't do it, you may need a new keypad. Catriver..post ...
...you need to open the control panel and there is a ribbon cable you remove from the main control board then plug the unit back in to see if the F1 is gone if so you need to replace the Touch ...
...ribbon to remove. Reverse process to reinstall. My LG oven/stove top would come on only when they wanted to. I have had numerous problems getting the buttons to work. Cleaning the ribbon made all of ...
...back. If it does, remove the ribbon cable again and power up with-out it attached. If the same error still returns, then I would suspect the control board itself. Catriver..post back. bad temp ...
Question about GE Kitchen Ranges
...remove the GE Profile gas range contol panel and replace it? Take out the 4 burner knobs, just pull them straight out. Then, you'll see those round holders for the burner knobs, about 1 1/2 inches in ...
1,583 questions posted
Usually answered in minutes!
390 Questions
104 Questions
83 Questions
77 Questions
70 Questions