...gas to flow has to be turned to the 'on' position from the 'pilot' position before main gas will flow. If is a "spark to pilot" ignition the knob has no 'pilot' position on the main gas valve and the ...
Question about Heating & Cooling
...Gas flow is good and Pilot is remaining lit with strong flame Changed thermo-coupler and cleaned pilot areas and burners(3 burners) Checked fan and electrical - All is working properly- Fan starts ...
...gas flow to the pilot and CW decreases flow to the pilot. It is essentially a "needle and seat" meaning the closer to the seat the needle is, the more restricted the gas is and conversely a CCW turn ...
Question about Heating & Cooling
...gas flow to pilot at end of thin tube. Hold this knob in the depressed position and light pilot. DO NOT release knob for 30 -45 seconds. Then release knob and pilot will remain lit. Then turn knob to ...
...gas to flow for the heater to ignite and warm the water.. Most controls have a Pilot position that you switch it to , than using a long match .. locate the pilot light in the access opening at the ...
so gas will flow. The function of the thermocouple is to confirm that the pilot is lit and allow gas to continue to flow when you release the valve. A new thermocouple is not that expensive. Good luck
Question about Uniflame Heating & Cooling
...gas flow problems which in turn could affect the size and direction the pilot flame. For if it does not touch the thermocouple, thermopile or whatever that little thingy is called that tells the gas ...
...Gas Flow Control Valve - Blew into small hose - Turned everything thing off include Gas Isolation Valve going into Gas Flow Control Valve. 27 Nov - Turned on Gas Flow Control Valve - Turned up ...
...gas flow) the pilot would still not light. Any suggestions? The Pilot indicator will appear to line up with the arrow on the base, and even push in as though allowing gas to flow, but if it is just ...
Question about Desa International Heating & Cooling
...that the safety switch is not allowing the gas to flow through. Check the connection of the thermocouple or replace it if connections are tight.Pilot safety valve may be badreplace gas control
28 questions posted
Usually answered in minutes!
21 Questions
16 Questions
17 Questions
15 Questions