GE JVM1660 Microwave Oven "filter noise" Questions

...the Magnetron tube. this is the main heating device. the noise filter is also damaged and, should be replaced as well. In conclusion, replacing the Magnetron tube and noise filter will fix this

...filter in place the noise doesn't seem to go off. What could be the problem? Is that something that I can fix by myself? Thanks. Maybe you and the person from the post below could get together and ...

the fuse and it's fine. I unplug the power to the noise filter and plug it back and it worked. It works temporary and then it died out on me again. Does this sounds like I need a noise filter replaced

...noise filter....(noise filter is a ciarcuit board mounted to one side, should see 2x 10a fuses on it and a small 1.25A)...underneath, a circuit board...thats the lv transformer assy. Check the 10A ...

...noise filter and running diode. these important components have failed at this point. you will need to replace these components asap, if possible. this will fix your issue. The Magnetron Cut-off fuse ...

...noise filter board near where the AC cord enters the chassis.On an over the counter model, the fuse is usually located behind the grille or control panel, or sometimes on a noise filter board near ...

noise. What can I do do fix it? I tried changing the Charcoal filter but I think we bought the wrong type same number on it but not aluminum. Hi, Here is a tip that will help you to figure out what is

...NOISE FILTER ON VIKING VMOC205 ALL FUNCTIONS PERFORM WELL..WAS TOLD NOISE WAS COMING FROM MAGNETRON SO I REPLACED BUT NOISE (HUM) STILL THERE IN ALL FUNCTIONS. IS THIS A NOISE FILTER PROBLEM??? The ...

...noise filter it's good, no lights or anything I didn't know they had noise filters! :) Then you have blown a fuse. Check inside the oven chamber and look for missing powder paint or signs of arcing, ...

...noise filter has failed. Just to make sure of the Magnetron failure, expose the device and, check the Magnetron temp fuse located near the device. this fuse will show no continuity when tested if ...