GE Spacemaker JVM1640SJ Microwave Oven "cause stop 2 seconds" Questions

...2 years old and cost alot what could be wrong with it? Even though these are different symptoms, the same part may be causing both. If the digital programmer circuit / controller does not get a ...

2-3 seconds Our ge spacemaker xl 1800 is about 2 1/2 years old. After we are asked to reset the clock (choosing clock, entering 222 then start) the clock is set. When we try to rerun the microwave, it

...STOP button) is the primary cause of door switch failure. It could also be due to a bad connection on your control circuit board. I repair those circuit boards all the time for that reason. I also ...

...2 new magnetrons. Now it starts to heat, runs about 30 seconds and stops. Everything is off, the light, the fan. Nothing works. We unplug it and it will start again..same problem.Stops dead. Also the ...

...2 -3 seconds and shuts down. My JVM1650CH02 does the same thing it runs for about three seconds and then stops. The display becomes garbled and the clock/calender has to be entered. Has anyone ...

...2 or 3 seconds. My wife thinks I'm crazy, but it seams to happen when we are heating small-ish food items, like baby-food in jars and cubes of frozen butter. The solution I have found is to put a ...

...cause of why your microwave is not heating. Test your microwave's magnetron. Replace it if it is defective.Testing a magnetronNOTE: Before you test this component, make sure your microwave is ...

...stop Our Dacor PCOR30 over stove microwave stops when there is 1 second left to go on a minute. Set at 3 minutes it runs to 2 minutes, 1 second and stops, push start again and it runs to 1 minute 2 ...

2 minutes, reset clock, tried to heat again, shuts off 23 seconds. No beep when it shuts off. It will keep the correct time. It will not go into child lock mode. Most likely cause, worth fixing or not

...SECONDS THEN STOPS There are a number of possible causes. The following link will take you to a page with the diagnostic flow chart that you can use to troubleshoot this issue: Microwave Fault Codes ...