Rinnai RHFE-1004FA 38,400 BTU Energy Saver Ductless Heater - Natural Gas "gas heater clicks within few" Questions

...gas will not flow in to start and ignitor turns off and whole thing stops. This repeats for 3 times and then systems shuts down. I do hear few clicks during this cycle. What can possibly be the ...

gas to the burner. Look for flame. There is a small probe that will sence flame within a few seconds and keep the unit on. If it doesn't, it will turn the unit off within 3-5 seconds. I suspect that a

...gas valve clicks burners light then gos out after a couple trys then blower kicks on but blows cold air- i tried changed filters replaced thermostat -igniter vacummed inside. sometime heat works then ...

...gas valve not holding at thermocouple connection 2. Hole in heatexchanger blowing out pilot when blower comes on I take it the pilot stays on untill fan comes on and keeps going out , I would think ...

...gas valve should open with a click. The flame will start at the burner closest to the igniter and travel away from the igniter. There is a small flame rod located in the flame path on the last burner ...

...heater doesnt come on. What will cause that? On a call for heat, the 24 volt thermostat sends a signal to the control module. The control module will indicate a call for heat with a light on the ...

...clicks" as if gas will come through but it doesn't lite. I have checked and there is gas pressure reaching the valve. Please help On a call for heat, the 24 volt thermostat sends a signal to the ...

clicks again and drops it out. The flame sensing rod has to see flame to rectify the ground signal to the circuit board very quickly or else raw gas would continue to dump into the heat chamber. After

...within the smaller Ford vehicles, due to their smaller alternators and loads. So, here are a few questions which may help to narrow down the culprit.Generally, this involves the fuel/air intake or ...

...gas valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a safety sensor will be looking for a certain temperature within a few ...