Question about HP LaserJet Office Equipment & Supplies
...guide on it. When duplexing,the paper comes out here, and then reenters the machine.I would try reseating the duplexer as I have had them dislodged by users sometimes when they are removing
...Reseat the duplexer (make sure that the printer is turned off). 3 Perform a service test. See page 213. 4 Perform a paper-path test. See page 213. 5 If the error persists, replace the duplexer (make ...
Question about HP LaserJet Office Equipment & Supplies
...rollers. Ensure the flags are present and not damaged. Remove the tray guides from the tray and reseat them. Ensure the guides are seated correctly and are in the correct slot for the size paper ...
...THANKS check for paper jam in duplexer - or it is not seated correctly. power cycle printer after reseating to re-init
will not duplex - fails duplex quick test Hello. Here are some suggestions from Lexmark as to why the printer will not duplex: The ability to select duplex printing requires the following: -The ...
Question about HP LaserJet Office Equipment & Supplies
...single sided only from Paper Tray 1. Does not recognize installed Duplexer or Paper Tray 2. try reseating printer on top of duplexer/tray. these 6 pin connectors have a clip on each side that is
Reseat the formatter. 2. If the printer has a duplexer installed, remove it. Turn off and turn on the printer, and see if the error clears. If the error clears, then, the duplexer PCA may be defective
Question about HP LaserJet Office Equipment & Supplies
...sent to the printer produces a "failed to print" window. Any suggestions? Cordially, Bob The duplexer might not be seated properly in the printer causing the carriage to jam. See if you can reseat
Question about HP LaserJet Office Equipment & Supplies
or duplexer selected as the paper source, and has detected that the Paper Cassette (Tray 2), which serves as a paper guide for the Lower Cassette, is not installed. Install (reseat) the Paper Cassette
...Error 59.90 refers to the problem with the transfer belt motor. Try to open the front cover and reseat the ETB, sometimes it helps. If the error appears again, probably you'll have to change the ...
52 questions posted
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions