control board but it has no lights on it. Id hate to see you order a control board when you need an interface board. Well if the leds are dim then remove top and reseat all ribbon cables 4 each on the
Question about Maytag Dryers
...control board. Unplug the dryer or turn off the breaker to the dryer. Double check to make sure dryer has no power. Remove the screws holding the top on at the back of the dryer. Standing in front of ...
...control board and the user interface control board assemblies. Unplug the dryer. Check the wire harness connections between the main electronic control board and the user interface control board ...
control board. The thermistor attaches to the control board on the P2 connector (red/white and black wires on pins 5 and 6). The image below shows the procedure for accessing the control board in this
...Control Board failure. It is likely that the machine control board will need to be replaced to correct this problem. The part number for the machine control board is undetermineable because you have ...
...Control Board failure. It is likely that the machine control board will need to be replaced to correct this problem. The part number for the machine control board is undetermineable because you have ...
control board - however there is a red light that will flash, replaced thermol fuse, main control board, control board behind the start button- (2) - replaced - hi limit behind the thermol fuse. After
...Control Board failure. It is likely that the machine control board will need to be replaced to correct this problem. The part number for the machine control board is undetermineable because you have ...
...Checked 220V input - fine Replaced control board Replaced control panel board. Absolutely nothing. check for main power at control board, if no power at board then cable/cord probably needs ...
339 questions posted
Usually answered in minutes!
208 Questions
116 Questions
93 Questions
75 Questions
51 Questions