...Error Light sequences Here are the instructions to do that: 1. Turn off the printer. 2. Open the front access cover 3. Press and hold the red Stop button while powering up the printer. 4. The lights ...
Question about Lexmark E Office Equipment & Supplies
...cycle on the operator panel. Once the Error light is solid, Release both the buttons. Close the Front cover. 4. Restart the printer to enable the changes to take effect. This process enables you to ...
...error. After speaking to Lexmark Support, they said try replacing the photoconductor kit. I did...it wasn't the problem. Up until a few days ago, all was fine. Any suggestions for further ...
...cycle. When just the Error light (!) is displayed, close the front cover. The top four lights of the operator panel should come on, indicating that the printer is in configuration mode. Print the ...
Question about Lexmark E Office Equipment & Supplies
cycle a few times, let go of the Continue button Close the front of the printer when the yellow light is on, telling you that there is an error (because the front cover is open) There will be 4 lights
...cycle. When just the Error light (!) is displayed, close the front cover. The top four lights of the operator panel should come on, indicating that the printer is in configuration mode. Print the ...
Question about Dell Office Equipment & Supplies
...Error light is on, close the front door. At this point Continue, Ready/Data, Toner Low, and Load Paper should all be lit. If the previous set of steps did not go as described then do not continue. ...
Question about Kodak Office Equipment & Supplies
...error continues even after you close the printer access door, power cycle the printer: Turn off the power (press the On/Off button on the printer). Unplug the printer power cord from the back of the ...
...error and cycle power to continue By any chance do you have a duplexer on this printer? The error code says that the duplexer has a bad fan. Power down the printer and remove the duplexer. Power up ...
...ERROR alternates with CYCLE POWER TO CONTINUE An internal communications error occurred. The page containing the error will automatically be reprinted. 1. Check the power at the printer location. 2. ...
285 questions posted
Usually answered in minutes!
224 Questions
106 Questions
83 Questions
56 Questions
79 Questions