no power, display lights nothing seems to light up, not sure, there is power in the unit though? Check power into and out of the transformer. You should have either 115 or 230 VAC in and 24 VAC out. ...
No power to heater minimax 400 pentair I was heating my pool for about three hours and everything was fine.Now i have NO power to my heating unit at all and my pool pumps won't turn on even though i ...
My mini max NT 400 shows it is not getting power. Nothing on the display is lit. Not sure where to start, any help is appreciated. Thanks Start at the begining, make sure you have power going to the ...
...and filter will not work but our water fall runs ok firs check the breaker if not trip check power at the relay if power than check at the back of the motor for the filter if power replace ...
...then the system goes into GVO mode. Here is the directions from raypak on this code. 1. Turn off power and disconnect ignition wire and gas valve wires from cpu board. 2. Turn on the power and ...
red light/heat won't come on when I turn the heater knob. The breaker is not tripped and I have power. You may have a burned out heater element. These can be checked with a volt/ohm meter with the
i have a model model 205 WG-P i purchased used but no manual do i need tu run 120 ac power to the unit i dont see where they had power running to it before Unless this heater has electronic ignition ...
what does FL-5 mean on a laars lite2 heater Heater doesn't work, when power is turned on the code fl-5 appears If all voltage test points are within range, then it's 1 of 3 problems: Power Conversion ...
172 questions posted
Usually answered in minutes!
774 Questions
104 Questions
113 Questions
87 Questions
78 Questions
