Broken Water Channel Hose Assembly Machine will not suction up dirty water. Found broken water channel hose assembly. How do I replace the broken channel hose assembly? I have a new hose assembly on ...
Switch Assembly Brush bar stopped rotating, removed floor piece, cleaned. Did not resolve. Removed Swithch assembly and one of the two springs dropped out. We cannot determne where it should be placed
Question about Hoover Vacuums
how to remove the brush roll from th assembly on a Hoover steam vac I got the assembly part off now I need to rremove the brush roll Just pull the brush assembly straight out slightly and look for ...
...SEND ME AN APPROPRIATE FIGURE DIAGRAM. Remove the lower plate Carefully lift up on the agitator assembly until it clears both sides of the nozzle housing. Remove the belt from the motor shaft by ...
...it please? If it is not staying up the handle falls down then is caused by the handle spring assembly. Replace the assembly and it should do just fine. There about 7 different components
...likely a broken drive belt. You will have to remove the vacuum base cover, then remove the roller assembly from the vacumm base to replace the belt. After you remove the roller assembly put the new ...
Why are the brushes not spinning? The front wheel assembly got broken along with the snap pin and I bought new ones but I don't know what the snap pin attached to so I'm thinking that's whatever is ...
...Any help would be appreciated! Raise the light assessory on the front of the vac. Remove the roller assembly by rotating the square dial as indicated by the arrows. Then you must attach the accessory ...
Switch Assembly Brush bar stopped rotating, removed floor piece, cleaned. Did not resolve. Removed Swithch assembly and one of the two springs dropped out. We cannot determne where it should be placed
42 questions posted
Usually answered in minutes!
157 Questions
154 Questions
86 Questions
80 Questions
71 Questions