RTO Spur Sprocket For Stihl 017, 021 Chainsaws "chainsaw stops running choke closed" Questions

...chainsaw in setup. the choke is operated by the fingers on the handle grip...the lever is stop...on...choke...when motor running just flick back up to run mode...the choke butterfly is just a open or ...

...running at 3/4 speed, the choke is still half closed and I can't slow it to idle. The only way I can stop the saw is to push it to choke and flood it to stop. What's the problem? Greg ...

...choke on(fired and died) but it starts without chk fine. when started w/o chk it revs and spins the chain for about 15 seconds then the chain stops and it idles after that I can cut with it for about ...

running without full choke on. Managed to cut lawn but not running right...any ideas? Replaced fuel filter(previous one on backwards),also replaced spark plugs, but put old ones back in. Still have to

...running for a few minutes. Loosen fuel cap when it starts to sputter (rotate saw if necessary) if it picks up again bad vent. Most likely it was flooded. A flooded saw can be extremely difficult to ...

...choke (fast idle maintained) pull starter until it starts. Usually first pull) Warm: 1., 2. (without pulling starter), 3.. Hope this helps Lou Make sure the air cleaner foam is clean. I sometimes use ...

...choke closed on some saws); pull starter and listen for an attempt to start (or the Decomp pops) once heard (usually two pulls; no more than 4)Set compression release ? optional step even if saw is ...

running at high speed. Starts fine, Idles fine. Just won't run at speed. Air, fuel filters are clean, plug looks good. Choke works fine. Spark arrestor clear. I'll try the high speed needle next. That

stihl ht75 wont start. Its almost new! Is it still under warranty? If so, take advantage. If not, remove the spark plug and check for spark with a clean plug. If nothing, likely the ignition module ...

...stops) CCW 1-1/2 turns each. Start the engine and allow to warm up. Hold the throttle wide open and turn H CW until the engine speeds up, but still 4-stroking. Correct setting is when the engine ...