Excalibur. K9-MUNDIAL-SS Entry Level Auto Alarm with Dual Zone Shock Sensor "blue light flashing car security" Questions

attention to the vehicle. Can that be done? The flashing blue light is to tell potential thieves that the vehicle is armed with a security system, making a potential thief less likely to break into it

...blue light is to let potential thieves know that there is an alarm in the car. it uses minimal power and should not drain your battery. mine would drain my (new) battery and I know it was that light ...

...blue light is off no flashing nothing 2010 Toyota Corrolla had installed about 3 years ago. Just all of a sudden did not start this morning and I noticed blue light not on in car on the little black ...

...Blue light on remote flashes, but car does not flash lights or start. Please help. Thank you. It can be caused by water in the pin switch and because is very cold it may be iced inside the switch and ...

...blue light that flashes on the windshield for the car alarm doesnt flash anymore. nothing works on the remote start system. everthing worked before i cleaned the interior out. The alarm is in Valet ...

...blue light stays on the little receiver/antenna on the windshield wheather it is locked or not. What is the problem? sounds like the alarm went into valet mode. that's usually what a solid blue light ...

...BLUE wire which drive the LED, and two pins on the unit which have no connections. The LED will only light when you get these the correct way around. You will not do no harm if you connect them the ...

...pin connectors you may see an orange and a pink. At the next injector you may see an orange and a blue. The orange is the common wire and the pink and the blue are uncommon wires. You may connect ...

...blue and green. The red power (with fuses) wires from the Viper should be connected to either of the two. The ignition wire is yellow. The pink wire from the Viper should be connected there. The ...