Bosch Axxis WFL 2060 Front Load Washer "washing machines check tap" Questions

...check out the filter in the hose at the tap or at the washing machine end next replace the water inlet solenoid you can check this by changing the hose from the hot water tap onto the cold water tap ...

...washing machine I have a ecosmart GWL15 Check that you have sufficient water pressure from the tap, remove the water pipe to the tap, hold a bucket under the tap and check the water pressure. At the ...

...check if leaking. In case it is the washing machine, try to replace hose or the connector on the back of machine. Make sure also all rubber seals are replaced with new ones. If under machine you will ...

tap and tell machine to do a hot wash - only good if you only want cold washes 2) check where hoses connect to machine at rear - sometimes a fine mesh filter that has become clogged - may be at either

washing machine takes about 1 hour between prewash and spin dry cycle. Water just dribbles in. check the operation of the solenoid valve check that the tap washer is opening with the turning of the ...

washing machine hose is suddenly poor. The tap itself is only half turning compared to the other 3 taps and is a wee bit stiffer. Any clues? Is definitely the tub not the machine as I have checked the

...washing machine hoses to taps & turned on the water, however when I turned the machine on, the water does not go through to the machine, what could be the cause? Check to make sure you have water ...

...washing machine model 200 MONZL hi just read your posting.1st remove both inlet hoses from the taps and the machine.Check if there are little filters on the ends of the hoses,They could be ...

...Check seals on hose at the back of machine. You can always find old sets of hoses as well (or buy them), so you can try swapping them over. Keep in mind, with washing machine hoses (like gardening ...

...washing machine. The water tap closed light keeps coming on during wash cycle. Both hot and cold taps are on. Whats the problem? Could be dirt in the inlet valve remove the hoses and check/clean ...