power off, then turn gas off and replace it. then you should be ready to go. to relight heater hold down on gas vavle knob in the pilot position, hold down and light it at the coupling where gas comes
Question about Water Heaters
power to autostart but the coupler may be gone if you are holding that pilot start button down for several min and the pilot light is still going out..ps.. leave it in pilot mode for several min after
...power vent runs constant Pilot light stays on after unplugging...Burnner fires when pluged in... pilot light will stay on if it is a standing pilot. Turn water heater aqustat down and plug back in. ...
Question about Water Heaters
...power in heater box. You have to hold the button down in the pilot position to allow gas to go to the pilot while you click the igniter. Hold the button down for a minute or two to allow the ...
power to the main gas valve. The gas valve has a electro magnet which hold the valve open. If the thermalcouple goes bad it shuts down. Reasons dirty Pilot flame not hitting the t/c, no electricity is
...Power Vent propane water heater model3 21VP4OE-1P that is acting up. The pilot lights and then the burner lights, but goes off after 5 - 10 seconds. It cycles like this 2 or 3 times, then stops while ...
Question about Reliance Water Heaters
...down putting out pilot lite pilot will re lite and run again and then it shuts off everything Short cycling on power vent can be bad pressure switch or bad gas control ...
down. and it keeps repeating this cycle until I turn the switch off. after a couple days I can repeat this and it will do the same thing. Is this maybe the control valve? Doug it is the control valve
Question about Rheem Water Heaters
...power vented hot water heater. You may as well unplug it because the induction fan will continue to run. Hopefully your propane company is responsible enough to perform a gas leak check on your ...
259 questions posted
Usually answered in minutes!
249 Questions
27 Questions
22 Questions