...between the blade and anything else. Finding none,remove blade. Try motor w/o blade. If it runs now,w/o the blade then the motor is likely ok . Reinstall blade. Now if it stil stalls, Replace
motor is running back wards I have a milwaukee miter saw I put in new blade and find motor was running backwards . When I put blade in right the wood just smokes . I,ve had this saw for over 10 yrs JM
...blade to motor. If your blade rolls free, and the motor shaft moves freely, then the motor winding has gone bad, so replace motor. Add a comment for more free help. Also take advantage of fixya phone ...
...motor is not running chances are it is the jackshaft. Take the motor off and remove the jackshaft housing. (the jackshaft has a gear on the backside and the blade attaches at the front side) If the ...
...motor then the blade another flange next to the blade then the nut.. When you hold the inside flange with a wrench that came with the saw and tighten the outside nut it locks the motor when trying to ...
...blade to the motor has worked loose. You need to remove the plate around the blade to acess it and on the end of the blade is a large nut. Tighten it with the power off. Sometime there is a grove on ...
...motor runs but the blade does not turn UNPLUG the saw! IF your saw is a direct drive; either the blade is loose or the center of the blade is broken, Or the motor shaft has broke off. IF your saw is ...
...running indicating the armature/field are burnt from possibly overloading with a dull blade. The Bosch 4000 series had a few inherent issues: #1) Is the rear armature bearing - often when this fails ...
...the blade lock nut and tension washer. This you will know because the blade will begin to snow and not cut the material, yet the motor sounds as if it is running standard speed. Good Luck< ...
...motor runs but the blade won't turn. The blade is attached to the motor. I would check to see that ID of the blade arbor matches the OD of the motor arbor, and you are not missing an adapter ring. ...
473 questions posted
Usually answered in minutes!