Honda Karcher G2400HH-R Pressure Washer "change wand" Questions

...then an increase in pressure for a short period of time followed by very low pressure. This pattern then repeats itself. Bad wand or bad wand tip. Do a complete engine tune up and oil change. 30w

...wand. The pressure is on for about 2-3 seconds and then it dies down like a water hose pressure for the same amount of time. It keeps doing this the whole time I press on the wand change the ...

...change it. When a new spill valve is put in....always run the pump with no load. This by usiing the gun without lance or wands, resulting in low pressure. If all OK...add a lance or wand that you are ...

pressure washer cuts off when I pull trigger on wand. I changed the oil it is getting better but seems the oil sensor is cutting it off. Float may be sticking in carb.

change attachments on macallister pressure washer I assume you have a QD quick disconnect on the end of your wand...it is a brass piece that slides back the collar allowing you to pull out and push in

...pressure washer. the fitting that attaches to the wand near the handle leaks excessively. Have changed rubber o-rings but this doesn't help. Please help! Thanks, Neven Long. hav you tried using ...

...is after a total fuel change Blew out carb with compressor..... If I let it sit start with no choke when it coughs Always hold wand trigger open when starting. No carb adjustments on

...new last fall started on second pull everytime. have filled oil, and gas, cleaned air filter, changed spark plug, made sure wire is connected. when I let pressure off of the wand does not seem ...

...used it 5times over the last 3 years. It was working find and suddenly lost pressure. The engine sounds fine. I change the wand however still no pressure check the o-ring in the pressure relief

Gas driven portable pressure washer no longer draws chemicals up "Generac Portables" Model #GC160, 5hp Honda gasoline engine, 2300 psi delivery. Upcomer is small diameter (3/16" or 1/4") clear ...