Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw "flywheel cut saw" Questions

...flywheel or cut yourself a 'woodruff key' of the same thickness as the groove on the crank shaft and cut a corresponding groove into the flywheel EXACTLY where moulded key used to be. Refit the ...

saw will idle but when you give it gas it cuts off Check the fuel filter, air cleaner, and muffler for plugging. Check the condition of the fuel lines for decay or other damage. Check the spark plug ...

...flywheel. If you can't then you have piston and cylinder damage. I wasn't unable to look at the parts list for this saw as it didn't shown up. Depending on the cost of the parts you be better off ...

...cut out. You need four main things for the saw to start, good compression ( remove the muffler and check the condition of the piston through the open exhaust port, look for signs of scuffing on the ...

...flywheel from the driveshaft and check the condition of the key. if the key is not perfectly square, it needs to be replaced. Damage to the key occurs when the saw blade has been stopped suddenly ...

...saw to quit running after about ten minutes of cutting Starts great when cold and runs and idles well for about ten minutes, then will not run. Let it sit for about twenty minutes, then it is hard to ...

...saw 4-stroke at speed when running free, but immediately 2-stroke when cutting? If not, adjust the H jet needle CCW somewhat until the previous occurs. If the engine seems to be about normal ...

...WAY OF CHECKING COIL OR BEYOND HARD STARTING BEFORE THEN JUST QUITE WHILE I WAS CUTTING Remove the flywheel cover to expose the flywheel and the ignition module. Remove the ignition switch wire from ...

5521 bbc mower backfired then stopped only backfires when i try to start possibly the key is cut off in the flywheel

Makita cut off saw ek7301 what is the coil air gap Between the coil and the flywheel use a business card not plastic though it won,t bend enough.