Breville CBL10 BlendMaster Classic Work Top Blender "removing tight blender" Questions

...blender blade fixture. I can buy the replacement part but I have no idea on how to properly remove it. I'm talking about the white plastic part opposite to the blade that fits to the drive on the ...

removing the blade assembly, how to remove the blades Thank you! The shaft has probably become tight in the bearings and the assembly will need to be dismantled for cleaning and possibly lubrication -

...tight. When the latter gets loose, the blender shakes and leaks. To fix it, first you have to remove the top nut holding the blade on. I had to get in there with pliers, but a ratchet with an ...

How can I change the blade for my 2 speed hand mixer? The model type is NC-12 if you need to know you are using your KitchenAid blender and it stops blending, you may think there is a problem with the

...tight with a bench vise to be able to remove the clutch. Hope this helps. -Vince Remove 3 screws on the bottom of the blender Pull off cover Use a screwdriver to keep the motor's shaft from spinning ...

blender is leaking. It appears that the locking ring may have been screwed in a bit crooked as the rubber washer is not sitting flush and tight. My problem is that the locking ring is so tight I can't

bottom blade can't be removed The bottom piece that holds the blade was screwed on so tight that I can't remove it. Any chance you'd have a way to remove it? go to a good hardware store and buy some ...

Blender. -Possibly not the spline plastic. -Inside on top of the motor there is a planetary gear there. Possibly worn out or lose screws as well that not hold it in place to mesh together. -But before

...Blender I ordered a replacement clutch assembly but can't figure aout hou to remove the old one. Can anyone help? Remove the little rubber feed on the bottom of the base (they might be glued a bit so ...

...tight for me to just unscrew it by hand. Deb66, you may have found this already, but there is another thread on this site that addresses this same problem. . . ...