Cuisinart DCC-1200 Coffee Maker "set auto brewing" Questions

...Auto On 1. Set the desired Brew-Start time. a. Turn the FUNCTION KNOB to ?Prog?. b. Set the time you want coffee to begin brewing by using the minute and hour push-buttons. Follow the same ...

...set the coffee maker to brew and turned it on it brewed the coffee but at some point the warming plate turne itself off so it wasn't hot for my husband when he got up. My old coffee maker just stayed ...

...Auto Off? position. Press and hold the ?Hour? button for 2 seconds. The clock display will start blinking. 2. Program the coffeemaker to shut off from zero to four hours after brew cycle is finished ...

...set the coffeemaker back to Auto-Off and see if your problem is resolved. If not, it may have deeper problems. These coffeemakers have a 3-year warranty - call Cuisinart to see if you are still ...

...auto start on my coffee maker stopped working. I set it as always, the green light goes on, but when I check in the morning, there is no green light and the machine has not brewed the coffee. I can ...

for two seconds, until the clock display starts blinking. To change the hour and minutes, use the pushbuttons as you would to set the time of day. The Auto Off time can be set from zero to four hours.

...auto brew feature for the past week.That was before last night, then I went and put in more water than I should have..poured out the back some but wasn't a huge amount. Now, it will not turn on to ...

...set my auto off button. It had been set to 0 so it shut off as soon as it started brewing. If you turn the switch to auto off, then when the numbers are blinking hit the hour button until you get the ...

...set for a reasonable amount of time for you. We have the user manual at the link provided: DCC-1200 Manual. If you run into more issues with the auto off there might be a problem with the board in ...

zero hours. You can set it up to 4 hours in 1-hour increments. Once you have set AUTO OFF to something greater than zero, you can restart the timing cycle by cycling the on-off switch off then back on