Question about Watts Electrical Supplies
...FROM BRIGGS &STRATON MOTOR Remove all wiring. Remove four stator bolts. Remove stator. remove rotor through bolt tap end of rotor us a shaft in the rotor tighten bolt in tapped hole to remove ...
...When you take off the back mount and then you will see inside a coil that rotates, this is the rotor, and a coil that is stationary around the rotor, this is the stator. Make sure that you take ...
how to remove the rotor remove the bolt that goes threw the middle of the rotor to the engine you my need to hitt the rotor with a hammer but place a block of wood between the hammer and the ...
Question about Porter Cable Electrical Supplies
Does anyone know how to remove the rotor assembly from the engine? I am assuming that you have removed the end bell with field winding and the only obstacle is the rotor on the crank of the engine. I ...
Question about Coleman Electrical Supplies
...engine off but i can't seem to separate the engine from generator It generally has a long rotor through bolt accessibile from the generator end, this forces the generator rotor onto a ...
...bolts mounting generator/stator housing to frame and carefuflly pull off leaving only armature /rotor on the crank of the engine. Remove the long bolt thru rotor into crank. Now you will need to ...
How do you remove the rotor from a Sears Craftsman 3600 watt generator model no. 580.323602? The rotor is attached to the crank via taperlock. You must remove the rotor bolt which goes thru the rear ...
Question about Coleman Electrical Supplies
how is the armature attached to the crankshaft on a Coleman Powermate 54 series? the rotor has one bolt that goes through the rotor shaft into the crankshaft. the rotor is tapered to fit the ...
...removal prevent armature (rotor) from completely off as you loosed it. To loosen place a wooden 2x4 against the side of the rotor and give it good smack with a heavy hammer to jar the rotor off the ...
How to remove generator rotor to replace piston rings. Have already removed endbell and stator.just don't know how to remove rotor. There should be a long bolt in the end of the rotor that screws into
73 questions posted
Usually answered in minutes!
549 Questions
64 Questions
57 Questions
