miller 3080 plasma ,won't fire ready lite on , have air flow and pressure, no mspark no fire check groun dconnection on workpiece and where connected to machine>> check reset switch.> There is a screw
it runs when u press the trigger theres no fire or air comes out Is the compressed air pressure in the limits for the unit to work. try turning the pressure up.
...cutter is 50 amp.i would really appriciate any help the spark that you see when you touch work peice is high frequency,recheck connections like good ground (tight and clean)on the unit and work ...
pull the trigger ,air comes out no fire Ck the ground and the condition of the tip. The more it gets concave the harder it gets to get a arch. Gun angle is also important, hold at right angle to work ...
...cutter just flashes fault everytime you try and use it. could it be the ground or would it be the electrod check the main lead to the torch,if there is a cut or any hole in the rubber coating it will ...
it runs but when you press tha trigger theres no I have a spectrum 3080 it runs ok the fan runs ok but when you press the trigger theres no fire at all can you tell me where can i find a manual of ...
my miller spectrum 701 was set up for 1ph 230 and got plugged into 460 and fire shot out of it several times.what would it take to fix it? I'm not recommending that you do this, but if you were to
safety light i turn machine on and have proper voltage and air pressure. after a sec. the safety light goes on and the machine will not operate check the gun lead all the way back to unit,if there is ...
Question about Miller Welding Tools
...to address the pressure drop assuming your air source is able to deliver adequate volume to the cutter continuously and you currently have more than 25 feet of hose between cutter and
1 questions posted
Usually answered in minutes!
5 Questions
5 Questions