spectrum 2050 plasma cutter . Cutter blows air and stops when trigger is pulled no pilot arc or any cutting when trig is released air flows again and stop after 10 sec new tips was working the day ...
Fault light is on all the time. Is there a fuse ? Hi: No there is no fuse for the fault light. Fault light it's on only when: 1) Voltage is wrong or not enough. 2) Overheated machine and needs to ...
my plasma cutter just flashes fault everytime you try and use it. could it be the ground or would it be the electrod check the main lead to the torch,if there is a cut or any hole in the rubber ...
Plasma cutter Hi, I have new plasma cutter 40 Am, In test it did cut up to 10 mm easily but now some time it is not cutting 10 mm mild steel. It is still ok on 6mm steel with full current. I did ...
my miller spectrum 701 was set up for 1ph 230 and got plugged into 460 and fire shot out of it several times.what would it take to fix it? I'm not recommending that you do this, but if you were to
Question about Miller Welding Tools
esab plasma cutter fault light comes on as soon as it is turned on The cable or cutting head may be damaged. The power connections may be loose, an internal circuit breaker may have failed
It does not work it just flashes the fault bulb and keep blowing air but does not star anything (not the electric arc not even the fan) when mine act like that I check the tip make sure the air ...
a red fault light is illuminated all the time it wont work The 3 reasons which will cause the infamous red light of death to come on and the machine not function, is because of over/under voltage ...
has cup fault Check connections on holder and at the main unit. blow out the unit with air to eliminate conductive dust as being a problem. Also make sure cup seating area is clean.
1 questions posted
Usually answered in minutes!
5 Questions
5 Questions