RTO Lawn Boy 6.75hp Mower "spark plug four" Questions

...spark plug lead from the spark plug and move away from cylinder head. Always do this before attempting any repairs to a lawnmower. 2 If your lawnmower is a "four stroke" mower (separate gasoline and ...

...to remove it. Dont forget to check that the little wire is plugged in other wise it wont shut off. Replace the spark plug and spark plug boot/wire as well as the flywheel cover and it should start

...spark plug removed, the engine turned over with the starter to blow the oill, gas, and water out of the cylinder(s), the plug should be either dried and gap reset, and the gas tank drained and FRESH ...

...spark plugs will most likely need cleaning due to the excess oil not igniting..just drain add new fresh gas and ckean the plug..start and now..if you are talking two stoke oil in the block if a four ...

...spark plug wire off.Check and see if you can turn the blade by hand one complete turn to make sure nothing is holding blade back. Sometimes the factory puts a block under neath for shipping. Replace ...

...spark plug and check the air filter (may have puked up oil and clogged the filter....even laying the mower on the airfilter side will do this. or if its a two stroke mower and you put in to much 2 ...

...spark plug and cleaned air filter Only problem is that also overfilled oil reservoir will that keep it from starting? If so how can i get some oil out ? Is there a drain plug? Hi pt-- If you are ...

...tuneup and got it back Saturday and the problem still exists. The repairman said he changed oil, air filter, spark plug and adjusted the carb. Any suggestions? Is it a two stroke model or four

...spark plug, removed the muffler, removed the valve cover thinking it was just full of gas or oil and nothing works.. Your piston cylinder is partially full of oil and/or gas. Take the spark plug out ...

...spark plug. After a few minutes you can start it again but it only runs for a few minutes before stopping again. Your ignition coil is failing when it gets hot.make sure the cooling fins on the ...