Briggs & Stratton Briggs Stratton Intek V - Twin Vertical Ohv Engine with Electric Start 22 Hp, 1" X 3 5/32" Shaft, ModelNo. 44K777 - 0027 - E1 "22 hp runs wide" Questions

...hp intec runs wide open I have a 406777 that runs wide open. I can manually move the likage to idle down but spring tention takes it right back to wide open 24 hp briggs. replaced cam, exhaust lobe ...

hp b&s runs wide open 20 hp b&s runs wide open sounds like the gov. fell out in to the oil pan. if you remove the gov. springs and let the gov. arm move up. it will fall out. no book will till

...runs at an idle and at high rpms as soon as you start the mower blades the governor opens wide open and black smoke comes out the exhaust. seems like its choking out and the motor won't pull itself. ...

runs wide open and will not idal i was told the govanor was bad how do i fix it Us+ally the air cleaner has been put on backwards or the spring has been snagged or over tightened. the throttle spring.

...Runs for a couple of minutes wide open and then just dies after warming up and won't start again until cold. bad coil it will seem like a fuel issue and the spark will look fine threw the ...

...hp runs fine for 5 minutes then starts to smoke an miss and will stop runing a few minutes later i have changed the oil making sure it has proper amount, put new air filter on, and a new spark plug ...

...runs wide open when set @ slow speed It could be that the governor spring has become disconnected or has broken on an end where it hooks onto the throttle linkage. If the spring is OK & throttle ...

...runs but i cant get it to throttle down. I split the case again and inspected the governor. seems fine. i adjusted the governor by loosening the governor arm and turning the governor all the way to ...

runs for couple of minutes then dies. Acts as if its not getting fuel. It is a 13.5 briggs and stratton engine. Could it be fuel filter? Is there an oil filter? some have fuel filter some do not , but

18hp B&S wont slow down no matter where 18hp Briggs intek wont slow down no matter where throttle is set It's one of two things. Most likely, the screw(s) have come out of the butterfly valve on ...