...door seal on my hotpoint WD420 washer / dryer First switch off electrics , Remove door interlock , leave wires on .remove soap dispenser,remove front panel with controls 3 screws top of machine 3 ...
dryer. I started a load and there was water leaking all over my floor from the washer, so I immediately turned it off. Now I'm trying to get those clothes out and the door is locked and I can't get it
Question about LG Washing Machines
...door should it be left open or closed when no use. I recommend leaving the door slightly ajar when not in use. That way your rubber boot/door gasket doesn't get smelly or stinky. -Colleen @ ...
...door boot or the tub bearing going out. I recommend cleaning off the surface of the door boot and if you still get stained clothes I recommend having the rear tub & basket checked. I am also ...
Question about Maytag Washing Machines
...Door seal is very moldy. We have a Maytag Neptune stacked washer/dryer, model # MLE2000AZW. Water never completely drains from the tub resulting in the door seal to be extremely moldy. Had a simular ...
dryer the clothes come out smelly too. when the wash is done make sure there is no water left in the door boot You have to prop the washer door open after a load so that it dries completely before you
door gasket the door gasket/boot / seal on the front of the drum has a tear where to get a new part http://www.appliancepartspros.com/partsearch/modelsearch.aspx?model=Malber%20WD%201000
...door boot to cabinet and peel off the boot. the seal is then held onto the tub either by a large circular spring or maybe a clamp with a screw. if it is a spring, then just force the boot downwards ...
Question about Hotpoint Washing Machines
dryer model is GEW9250PW0. A lot of concerns have been raised about door bellows molding, mildewing, and/or ripping and needing replaced. A replacement bellow isn't cheap (prices vary, but are around
Question about Hotpoint Washing Machines
...door and try shutting it hard as front loaders close snug because of the rubber boot check your power too sounds like a bad connection some where, maybe the switch, but probably a bad or loose ...
207 questions posted
Usually answered in minutes!
886 Questions
666 Questions
541 Questions
485 Questions
500 Questions