2009 Ford Fusion "removing pin type retainers" Questions

...door trim panel (pull the door trim panel outward to release the pin-type retainers)Remove front door sail panel Disconnect mirror electrical connector Remove 3 exterior mirror nuts and exterior ...

...pin-type retainer. To install, tighten to 23 Nm (17 lb-ft). Remove the lower pin-type retainer from the front fender moulding. Remove the 2 rear pin-type retainers from the front fender moulding. ...

pin-type retainer. Remove the screws. Remove the wheel opening moulding. Remove the front fender splash shield (16103). Remove the screws. Remove the pin-type retainers. Remove the front fender splash

pin type retainers or fasteners I want to replace my cabin air filter on my 2002 Lincoln LS v-8. I don't know how to remove those fasteners or pin type retainers from the cowl cover. Any special tools

...pin-type retainers. The male part of the retainer will remain with the trim panel and the female part will remain with the door. NOTE: To release the door trim panel pin-type retainers, first pull ...

...removing the bulbs. Please rate if this helps you. thansk. R & R procedure: Remove the 5 pin type plastic retainers on the plastic sight shield. You may have to pry up on the middle of the ...

...pin-type retainers in the radiator air deflector. Position forward the air deflector. Remove the ambient air temperature sensor. Detach the pin-type retainer. Disconnect the electrical connector. ...

...pin-type retainer. Remove the gimp around the roof opening panel. Remove the sun visors. For additional information, refer to Sun Visor in this section. Position aside the door opening weatherstrips ...

pin is lined up with hole on both and lens falls out so keep a hold of it ----or you have the 2 long skinny bolts down to the lens unscrew them and pull lens forward from truck remove connector and to

...type retainers. Push the center of them in and remove the retainers. After you pull the cover off you can twist the bulb holder counter-clockwise and replace the bulb. Put the cover back in place and ...