...if wired improperly? Fan motors have rotations, clockwise and counter clockwise, lead end and opposite lead end. If you are looking at the motor from the fan blade side and the wires are on the ...
...the circuit. Usually they are 2 colors and you will either hook up the matching colors for CCW or opposite colors for CW. If you do not have these leads, you will more than likely have a non ...
Question about Heating & Cooling
...to make sure it is running in the right direction. if it has been tampered with or took apart before then there are 2 wires leading to the fan,if you reverse these wires it wil run opposite ...
...in, and you still aren't getting anything, then check for voltage on the load side of contactor (opposite from the inlet or lead side). If you are and you hear a hum from the compressor and the ...
Question about Frigidaire Heating & Cooling
...of each wire keep track of where they connect to then put the wires in the new contactor the exact opposite of what you rmoved them. Reinstall the cover and you should be good to ...
...wired up orange to orange and purple to purple. switch org to pur and pur to org and motor runs opposite direction. be sure you have a new correct cap for the new motor. every new motor should ...
...works. Stay warm. Hello, first try cleaning the flame sensor, this is a small rod that ison the opposite side of the igniter, use some steel wool clean it and reinstall. Make sure you turn off ...
Question about Honeywell Heating & Cooling
...demand, the zone 2 valve opens and both zone heat/cool. When either thermostat is satisfied the opposite zone valve closes and when both thermostat are satisfied both zone valves open. Hope this ...
...(under hood) and hot water hose to where they enter the fire wall leading to the inside of the cabin. The heater core and heat/ac exchanger is on the opposite side along with the blower fan
Question about Heating & Cooling
...for 120 vac. If u have the switch on and high voltage present there should be high voltage on the opposite terminal check with meter. In no voltage the sequencer is bad. Hope this helps. Oh if no ...
154 questions posted
Usually answered in minutes!
1,056 Questions
416 Questions
195 Questions
147 Questions
100 Questions