Kenmore 71812 / 71814 / 71819 Bottom Freezer Refrigerator "remove cover air damper" Questions

...remove the light cover on the ceiling,remove the 1/4 inch screws and drop the light assy.remove thhe filter cover on the right side so you can remove the damper assy.pop off the cover on the ...

...remove the cover in order to replace it I am trying to get to the auto damper control on a jenn air JCB2389grs. The cover that goes over the part has 2 latches I cant get out. any trick on how to get ...

...cover and styrofoam insulation inside the refrigerator section at the back where the damper is located to allow the cool air inside the compartment. I found the damper in the closed position, I ...

...cover to the water filter,remove the top two shelves then pop off the middle cover on the back wall,this allows you to remove the two screws that are behind it,remove all screws and remove the damper ...

...air to continuosly come into the Refrigerator side, freezing all our food, to the point of breaking egg shells. I removed the vent cover and reattached the spring from the damper door to the Damper ...

...remove this cover and make sure ice is not blocking it up. if that is ok, then check the damper control to be sure it is opening and closing properly. The damper is located on the refrig side in the ...

...cover forward. 5 Remove the edge sealing device, radiant shield supporting screws at the back bottom center of the control housing mounting screw at back, bottom center of the control housing. Slide ...

...yourself you should disconnect the power to the refrigerator and remove the 2 screws holding the damper cover to the center wall. Sometimes you can spray the damper with WD40 and free it

...if you want to go cheap, remove the drawers and look on the back wall, if there is a vent on the BACK wall, cover it with tape, never cover the vent on the lower left, that is your cold air ...

...remove the control panel cover in your fresh food section. There is a belt that goes from your control nob to the air damper in the back of the control cover. This belt is not longer available. The ...