...not hot could be a number of problems. Checking with an ohm meter would determine the problem. Could be the booster high limit thermostat, a burnt wire, booster thermostat, or a heater
on the heater if it's good and less than one ohm on the high limit thermostat. If both of those devices check good, then replace the control board because that's the one device you cannot test
check for power to coil High limit snap thermostat may be tripped or damaged ( needs to be manually reset). located in heater connection cover. Thermistor probe and or wiring to it may be damaged main
...check for burn marks/melting), high limit thermostat (mounted on bottom of tub against tub, detects if tub overheats), thermistor (screw in mount near motor, detects process temp inside dishwasher, ...
...Check heating element for continuity. Same on high limit thermostat located near to the element. Test fan by energizing. Test the dryness sensor by jumping it. The tests above must be done by a ...
check the high limit (little red button on lower front panel, behind a plate) Otherwise you'll need a meter to check continuity for each thermostat (control/high limit), the coil on the contactor, the
...Check the high limit thermostat. This sits right behind the drain pump on the right and inserts into the tub housing. Remove the leads and check for continuity. 3. The vent wax motor is inoperable. ...
...high limit is doing its job.It would have some thing to do with control like the thermostat or the contactor could be sticking.Does this have a float in it.Is it clean.Do you have hard water.Is water ...
Check the operations of the High limit Thermostat The thermostat is installed in line between control board and element. If water is cold read impedance at thermostat's terminal. A good high limit
75 questions posted
Usually answered in minutes!
480 Questions
217 Questions
151 Questions
124 Questions
109 Questions