Danco Faucet Stem  "causes cold water shower" Questions

...cold water only, whatever temp setting. Runs tepid on occasions. Water flow at head decreases slightly with increased temp setting - but still just cold water. Is feed water pressure a likely cause ? ...

...cold in, and one port for tub and shower. You need to pull the valve and look for tears in the valve seat. As you give no details about your product check the following common cause:- Is somebody or ...

...cold water supply on, there is very low water volume when the cold is turned full on. Hot water supply is not available until I can eliminate supply line pressure as a possible cause. Is it possible ...

...been a problem before. it sounds like the flow is too low and causing the heat chamber to overheat ( or the heat sensor is faulty and thinks it is too hot) is the water too hot before it goes

...cold water only I sand paper cleaned the cold and hot water valves. Each valve slides freely in the plastic housing. If I rotate the valve assembly 180 degrees only the hot water works. What else ...

cold water! We replaced cartridge 2x - now what? check to see if cut off to the fauset is on if this is not the problem make sure there is a cold and hot water supply to unit check and make sure cause

...cold water off I replaced the hot and cold water knobs but it still leaks I didn't change the washers what is causing the problem replace the seats in faucet body -a special wrench is usually ...

...cold, pressure switch is not activating but pressure seems low any advise will be gratefully received. If the water temp is fluctuating from very hot and cool the problem could lie with a blockage in ...

cold water comes out when turned towards hot nothing happens..what is this Sounds like the anti-scald pressure balancing piece is stuck. This happens if the shower isn't used regularly. A varnish from

...cold water before, a new cartridge will solve the problem. In the future it would be wise to occassionally operate the valve at least a couple of times a month in order to keep the pressure assembly ...