KitchenAid Superba Architect KSCS25INSS Side by Side Refrigerator "cubes ice stuck" Questions

...ice cube stuck in the ice mold? If you have an ice cube stuck in there just heat the im with a hair dryer till the cube clears and fingers go around. Listen to see if you hear water going into the ...

ice cube stuck on crush Dispenser stuck in crush mode remove the ice bin,there must be a chunk of ice blocking the cubed dispenser chute of the dispenser and channeling all ice thru the chopper ...

ice but at a painfully slow rate - only 6-12 cubes/24 hours. Also, it will quite often 'jam'. A cube gets frozen but only partially ejected so that 5 out of 6 cubes end up in tray but the final one is

Ice cubes in ice cube tray get stuck you have either bad heater in ice maker or the coating is wearing off the cube holder (bottom of cube tray that water sits in)

...ice cubes stuck? If so, try turning it off and remove any ice cubes stuck to the wire signal arm or body of the ice maker and wait approximately 8 hrs.  Should these suggestions prove to be ...

STUCK IN THE CRUSHED ICE CYCLE WONT PUT OUT THE CUBED ?? EVEN WHEN I PUSH THE BUTTON BACK AND FORTH WONT SWITCH ?? if you have selected cubed on the door and still wont dispense cubed ice likely cause

ice is selected You have a solenoid switch which switches the dispenser back and forth from crushed to cube. It could be stuck or not working or the parts connecting it could be disconnected or broken

...cubes stuck in the ice cube tray and now wont make new ice. how can i get the ice out? i cant figure out how to access the ice tray without damaging anything get a hairdryer to melt the cubes unless ...

...ice cubes every 24 hours or so. Also, occasionally, the ice maker will try to eject the cubes and one cube (always the one farthest from the front/closest to the back) gets stuck. This leaves the ice ...

...ice cubes are stuck/frozen in the maker itself. If I reach in and break them off they start the process off again and the cubes get frozen and stuck again. I have tried lowering the temp in the ...