KitchenAid KGST307 Gas Kitchen Range "whirlpool ignitor keeps" Questions

Oven not heating to correct temperature The oven is heating to approximately 200 degrees less than the displayed cook temperature. I tried calibrating according to manual instructions and it did not ...

keeps going off. When you turn any knob to ignition the rate of the clicking picks up. Its a whirlpool gold just 5 burner top all ignitors lite thats the way the stove works thats a safty feature..but

plastic scrub brush to clean any grease or film from all surfaces. So the same with the burner seat and ignitor knob on the cooktop. The ignitor keeps striking because it cannot sense there is a flame

...whirlpool gas stove accubake super capacity 465 does not ignite or turn on.pls advise. Jay change the oven ignitor i get the parts from searspartsdirect.com I pulled the drawer out and watched as I ...

gas oven wont stay on belling gas oven lights ok but wont stay on when button is realised If this is electronic ignition, then chances are the burner or ignitor nub has residue on them, preventing the

...ignitor was faulty or wasn't connected properly? Please help. Code makes no sense compared to listed codes. E6 46 is a diagnostic code for a Whirlpool gas range. This code indicates that there is a ...

Model SF367. The oven trips my ground fault When the oven kicks on it trips the ground fault in the circuit im thinking you mean circuit breaker box...correct..you have a bare wire touch in check that

Whirlpool SF377PEGQ 0 ,Gas Oven not igniting... The oven doesnot light, nor do i have any gas smell when trying. The igniter does glow. The broiler does ignite. The top burners ignite. I can't seem to

Igniter in oven will try to ignite. Hear gas flow. Can see spark on upper burner assembly but it does not ignite. Use custom broil and it will ignite the upper burner but will not stay lit after ...

...keeps going on and off while in preheating mode Hi, The ignitor is not working right and is going bad.... have the repair man replace the ignitor, or DIY.... Check out this tip about your problem... ...