KitchenAid KESC307 Electric Kitchen Range "whirlpool oven hold temp" Questions

...temps do not agree with oven thermostat settings. Thanks, Greydaddy. Press and hold the bake button for 5 seconds, will go to calibrate mode, press the up or down temp to adjust yiour oven + or -

...oven temperature I have a whirlpool range 465 model # sf369lemo and the actual oven temperature does not match the readout or setpoint. I put an analog thermometer in the oven and it reads 25 degrees ...

oven is cool enough. Gene 243 Whirlpool super capacity 465- Oven will light and warm up to temp. The ignighter in the oven will then try restart to maintain temp but will not light. Will relight after

Oven gets to temp selected in 12 minutes versus the usual 8 minutes and once there and the door is opened to insert item to bake, the temp does not recover to the original setting (short by 20F). ...

Whirlpool Stove oven temperature not accurate I have a Whirlpool flat top stove, model #RF3663XDN0. When I set my oven temp the inside temp is approx 25 degrees lower than posted. I tried putting a ...

...whirlpool range mod rf368lxpq o replaed probe and panel still very slow to come to temp. pre heat goes to about 200 deg and then veryy slow to come up to temp and hold temp It sounds like one of the ...

...oven the entire time to restart it every time it shuts down.Whirlpool replaced the original control board and that fixed the problem for about 6 months and now it's starting to lock out again just ...

Oven not work Hello I have a whirlpool range which does not want to heat up.The model #is WUP39800. When you push the bake botton it comes onwith the oven temperture reading 70,and holding, after some

the two screws that hold in the sensor, Whirlpool part number 3148440, you can pull it out to cut and splice the wires together from inside the oven. Wire nuts are provided. The part cost about $70.00

whirlpool RF315 electric oven overheating when set to any temp. You need to replace the oven temperature sensor. Here is the part you need to order. To replace the sensor, remove the screw ...