Question about Bamix Blenders
...Loosen the spring blades on a Bamix mixer attachment The multipurpose blade is to tight, and I'm not sure how to loosen the spring blades. You are lucky. they usually fall off mine. However you can ...
...loosen at all. Any suggestions? How does the blade attach to the part that mates with the blender that turns the blades? keep trying it will loose unless it had worn out then you will have to replace ...
Whisk blade on BAMIX hand-held blender is frozen! I have tried soaking and running the blade end in boiling water (with a little liquid dishwashing soap added), however, the blade does not budge. Does
...blades turn? motor turns on. It hasn't been used for a few years When those things are not used for a while the blade assembly at bottom of mixing bowl freezes up. You need to unstick it with a flat ...
...blades by hand. Put a drop of alcohl at the point where the shaft comes through the case and turn to loosen the blade. Next, put a drop ov cooking oil at that same place every time you're finished ...
...loosen, not the left like usual. I had to clean out the rod that connects to the blades - it was all nasty and corroded. I cleaned it with my Dremel and regreased with a tube of grease I keep in the ...
...blades stop turning. no obvious damage to drive socket or gear on end of blade shaft.cant remove drive socket any suggestions on removal? Blade assy fits very loosly into drive socket and can be ...
Question about Vitamix Blenders
loosened blades on a vitamix 3600 stainless steel container The acorn nut on top of the blade assembly on our vitamix 3600 stainless steel container (with the twelve-point spindle) has spontaneously ...
...loosen. the rod that runs in the middle that's connected to the blades on mine was all corroded, so I sprayed it down with WD-40, took my Dremel to it and smoothed out the corrosion, added some fresh ...
Question about NINJA Blenders
...loosen I experienced the blades freezing on a different blender after making smoothies and letting the unit sit for some time. The problem was sugar seeping into bearing interface and solidifying. I ...
33 questions posted
Usually answered in minutes!
57 Questions
22 Questions