Question about Food Mixers
...put it back in. Something seems to be blocking y. The hole looks like it is aligned The hinge pin is normally locked in place by a screw. If that screw is not loosened enough the pin will not be easy ...
put the hinge pin back into the kitchen aid mixer The hinge pin came out of the mixer. How to I get it back in? Good morning, Sorry to hear you are having an issue with your appliance. We have create ...
Question about KitchenAid Food Mixers
...back in place you will be fine. To avoid this problem in the future you might remove the screw entirely and put a drop of "Lock-Tight" on it that will help hold the setscrew in place for a very long ...
Question about KitchenAid Food Mixers
pin is back in place, test the attachment hub to make sure it is secure and the attachments are properly locked in place. If you are still having trouble reinserting the pin, it may be best to contact
...put it back and take it to a repair shop later. To remove the head: First, make sure to unplug the mixer unit! Next, turn the unit upside down. Inside the neck, you will see a screw. Use a slotted ...
back where it belongs, making sure it is evenly engaged as too far in or out will make it foul. Put the rod back thru the lever and split pin it again. Check operation before you put the motor back on
Question about KitchenAid Food Mixers
...put the steel pin back in so the head will tilt without falling down Tip it upside down on a towel. Look deep inside the pedestal where the hinge pin goes through. Right in the middle there is a ...
Put it in the freezer, then install it set the head on the stand in the down position, leave unlocked. wrap one arm under the head and maneuver it until the pin goes in. Repeat to align the other side
...put back in or not put back in correctly or all the way through the center shaft and out the other side and the pin has fallen out. I which case the planetary should be slipping, remove the trim ring ...
Question about KitchenAid Food Mixers
...put it back..will only go through part way. Hinge pin came out from head of mixer and can't put it back..will only go through part way. did you turn your mixer over and unscrew the set screw ...
109 questions posted
Usually answered in minutes!
493 Questions
357 Questions
285 Questions
205 Questions
183 Questions