Krups Caffe Bistro 867 Espresso & Coffee Maker "wire pot switch" Questions

wire and element. Check to see if you are getting power through this switch. My pot's aluminum the heating tube was blocked by mineral deposits from the tap/bottled water. Try brewing a couple of cups

...switch at the back and also the front if there is one....place filter in cone..put coffee in filter...pot on burner...wait about 25 minutes until water in tank is hot...when light on front comes on ...

...wire(s), - Either way your pot is too old or badly damaged - Dump pot! * For die hards and cheapo's (like me) then you will need a continuity meter to check across the UNPLUGGED cord to see if the ...

...pot in an empty sink. 2. Remove the two Phillips screws located under the water fill flipper door. 3. Gently insert a small flat blade screw driver into the front top of the lid and remove top cover. ...

...pot run-through of clean water. If this works then you are good to go. Next, if this does not solve your problem we can do the following: unplug the unit and lay it on its back. You will need a #10 ...

...pot of vinegar water through the machine and still nothing. I'm going to presume that your brewer is a VPS series pour-over brewer. This problem can be caused by several things, so I'll list the most ...

...in to brew 1-4 cups to brew a whole pot. It's like a gremlin got inside of it and switched the wires. Try that with yours to see if that will work. I now use a clothes pin to keep the "on"

...Switch could be Intermittent ( Open ) also and a Replacement should Snap into Place and Leads attached as original or a safe way. A Simple Meter ( Harbor Freight ) Digital Meter only $3 will work for ...

...switch but nothing else happens the hot plate doesn't heat up and the water doesn't filter through While bikeman's fix was helpful and sure enough got the coffee maker to brew me one last pot of ...

...pot of coffee and re placed grounds and water then pressed start button and it would not start up. Any suggestions? Remove the on/off switch and check with an Ohm Meter for continuity. If one is not ...