...vacuum. Is there a button? Or should I just pull or push? I don't want to break it. Hi there,The Quick-draw Telescope Reach wand on your DC28 is designed to detatch from the cleaner automatically ...
...vacuum cleaner - you should see two grooves on the wand and two on the spine of the vac where the wand slides into - if you have any damage to either side, the wand won't click into place and stay ...
Question about Electrolux Vacuums
...separate motor from the vacuum cleaner. Also make sure the belts in the powerhead are good. Hope this helps. Likely a blockage in the two piece wand. Disconnect power head from the wand and the ...
...separate the wand from the hose and unwind the gray hose and stretch it out. Rub baby powder on the metal rod of the wand and in future, disconnect the wand from the hose and stretch/unwind the hose ...
...vacuum try and separate them again. It is unfortunately fair to assume that either one or both will need replacement but at least once their off the vacuum you will be able to see how bad it is. By ...
Question about Electrolux Vacuums
no suction when using wand on electrolux precision upright When I go to use the wand separately I have no suction. vacuum works fine otherwise/ There is a ball valve between the wand hose and the base
...vacuum cleaner and the basin on top of that. Now you will need the water hose (not the one that has the gas pump hadle). Hook that in the same spot that you do for vacuuming. Then you take the ...
can you wash clear bowl on a dyson dc44 I need to wash the clear bowl that the dirt goes in on a dyson animal dc44 handheld Hi there, it's Jack at Dyson. We would strongly advise against attempting to
...vacuum suction is weak. checked belt, fine. took brush apart and cleaned. brush seems to be rotating normally. Check for clogs in the nozzle air passages (remove bottom plate) Check for clogs in the ...
...separate the colored plastic from the base of the vacuum cleaner. There are 7 screws that need to be removed in order to get these housings separated. I have circled the location of each screw in the ...
23 questions posted
Usually answered in minutes!
184 Questions
178 Questions
164 Questions
89 Questions
74 Questions