Kenmore 30-pint Dehumidifier with Electronic Controls "display humidity" Questions

humidity display window always LO The humidity display window always shows LO. I thought over the winter it was because it was so cold and the humidity was very low, so we turned it off until spring. ...

humidity level keeps blinking on display , is that normal on the Albert dehumidifier What does the user manual say about this? That is normal when the room humidity level (as detected by the hygrostat

display shows both time and room humidity also set point humidity , the only way one can tell is on some models there is a tiny light that shows up next to labeled function , easy to miss It , also if

...display the actual room humidity. It has a built in hygrometer which will be on the display while it is running. You change it and it shows the actual levels. See page 5 on manual. ...

display and fan and compressor not working Could be the humidity is low enough it isn't turning on. Try to lower the humidity setting to see if it will turn on. Once the humidity gets down to about 50

humidity display fluctuates all over the map from 33 to the low sixties. i would like to be able to set it to a desired humidity level and have it turn on and off automatically as the desired level is

...display should show current room humidity , if set is pressed then display should show current set point for desired room humidity , this has to be less than first display otherwise the control will ...

...and replaced. HR202L. The humidifier started removing moisture normally but now have an E1 code displayed where the relative humidity should be displayed. Found corroded pins on the PC board ...

...humidity does not turn unit off. Humidistat LED display seems accurately showing 55-60%. Seems compressor always runs...don't hear it clicking off at all when raising humidity..I recall the fan and ...

...humidity is usually below 50%, yet the dehumidifier's display now typically reads 70 to 80% and seems to increase while the dehumidifier is running. Probably some glitch with the sensors. I recommend ...