Rowenta DG-980 Iron "steam trigger working" Questions

...steam trigger has a broken pin on the end inside the handle. Unplug the unit from the wall and let it cool. I found out that you can remove the main rubber cover by gently prying it up from the front ...

steam trigger is pulled You should hear the boiler heat up the water. When you pull/push the trigger, a pump should be activated and steam should be released. If the pump is not working, it could be a

...steam trigger Sounds like your trigger valve in the iron portion (not the tank) is jammed open. It could be from mineral deposits so maybe try running it with a solution of distilled water and a ...

...steam trigger it makes a weird noise. There are two cause. One the boiler resistance doesn´t turn of because of snap disc or bimetal thermostat fault or because a coil in the working valve (security ...

trigger inner actuator tab is broken...easy fix, just gently pry off cush rubber cover on handle from front to rear (gently to not scar up the works) and lift. Steamer not working?...is it getting hot

...trigger, a pump should be activated and steam should be released. If the pump is not working, it could be a defective capacitor according to this article:


A spare capacitor should cost ...

...steam is not coming through sole plate, changed the antiscale filter today as well, is there something i can do to make it work again, as not willing to buy new one, it is 3 years old. is there a ...

...trigger the button iron gets hot...but no steam. Try adding vinegar to the iron to dissolve any built up mineral deposits inside the steam passages. Put the vinegar in place of water, heat the iron ...

...steam at the iron. The trigger doesn't appear to be stuck. I would first try with household vinegar (empty as much water as possible) and if that doesn't work to free the valve, then something more ...

...trigger, a pump should be activated and steam should be released. If the pump is not working, it could be a defective capacitor acording to this article: ...