Question about Magic Bullet Blenders
...inside base catch cup so it won't seat properly it had been working for a couple weeks - I had not been using it - wife was using it - it stopped working - I looked at it and couldn't figure out how ...
Question about Magic Bullet Blenders
...inside of the power base. Push these downward to loosen it. Its full of sticky stuff because of overfilling. You can also put some oil on it. Buy parts from ebay and amazon seller amazingearth. is it ...
Question about KitchenAid Blenders
...base rather than going all the way down, if that makes sense. The collar totally fits the glass part and is the same as my old busted one (which also isn't fitting now, coincidentally!) Am I crazy, ...
Question about Blenders
...Anyone have a part number for the left hand thread nut of the brass variety with the retainer clip center, and teflon washer at the base of the inside cup where the small blade gear goes
...inside of the base that get pushed down when you push the cup in. Two of them have switches on them, sometimes they can break. Make sure they are being pushed down. If not, it could be one of the ...
...inside the jar ring base (turn it upside down) you will see little white tabby things in the slots, at least one of them has to be lined up with the 2 small grey contact points on the base of the ...
...inside of the black base. Then i discovered that there is a recess for an "O" ring, which seals the glass jug to the black base thus solving the leak. However there was no "O" ring in the recess and ...
Question about Blenders
...inside the glass pitcher and I can turn the piece on the top of the motor base into which the pitcher blade attachment fits. The base attachment turns when the blender is turned But when the pitcher ...
...inside the base is broken and needs replacing. my blade has a shaft that goes through a sealed bearing. when it's stuck boil in water for 5 minutes or so. Remove from water, with a nice thick cloth ...
...will sit inside the white base, with the blade facing upwards. The white rubber flange goes in next. Then screw the assembled base back into the clear jug. The jug should then fit on to the
20 questions posted
Usually answered in minutes!
9 Questions
15 Questions
1 Questions
4 Questions