Question about Amtrol Water Heaters
...control box or replace start capacitor: http://www.amazon.com/dp/B0060C7GFO/?tag=waterheaterti-20 Drain tank, and replace the air valve http://www.amazon.com/dp/B000BQYKJK/?tag=waterheaterti-20 ...
...then your vent may be blocked and the pressure switch is keeping the burner from coming on because of that. If air flow is okay then the switch is probably bad. Replace the pressure switch. ...
Question about Water Heaters
...air pressure switch that reads the pressure inside the vent pipe itself. It will have a small hose on it and if that has cracked or was not replaced it wont light. This is how its supposed to work--- ...
Question about General Electric Water Heaters
...pressure is still low. We never had problems ever and just started now. Do you have any suggestions to try. I did bleed the air out of the line after changing the filter. This could be caused by ...
Question about RTO Water Heaters
...We turn the manual switch off between uses. We did the procedure to regain air space. Copy following link for general TP troubleshoot ...
...air pressure switch-is case seal sealing properly also check grommets under boiler for blowing. YOU CAN ONLY WORK ON BOILER IF YOU ARE GAS SAFE REGISTERED. I agree - I;ve had to have the fan/switch ...
...air supply pathway, filters are clean, plumbing check valves, mixing valves, pressure valves etc are permitting one-way flow of hot water, water is softened to less than 11 grains hardness, water is ...
...replace. These have an induction motor - no repair Check the electrical contact wires to fan are ok. If the fan is ok check also the 2 plastic tubes to & from the air pressure unit [usually close ...
...air pressure switch is bad, motor is still good. Kohler is not helpful with replacing switch,told me for $400.00 for new motor I could fix my problem. Can I get a new switch or motor somewhere, for a ...
Question about Water Heaters
...air pressure with a tire gauge. It should be two psi lower that the cut in pressure. eg: If you have a 40/60 pressure switch, the tank should read 38 psi.If it is lower, charge it up with air. If it ...
2 questions posted
Usually answered in minutes!