Rheem 40 GAL ELEC TALL Water Heater 6YR SC 82VH402 "hook cold hot side" Questions

cold water hook up on a 71-40d which is which top and bottom Tanks are marked with Hot and Cold. 1) If water connections are on top of tank, look for red marking or word HOT that shows where hot water

...your at it hook a hose to the hot side connector and run it out side or to a sump pump then turn on the cold water and flush it out you can also reverse this procedure by doing it on the cold ...

...hot is the cold side hooked to the cold side if not you will be feeding the unit backwars making it to where the cold is just comming across the top of the tank, check the dip tube also, this makes ...

...cold water in the bottom of the heater which pushes the hot water to the top.To change the dip tube out you must disconnect the cold water supply from the 3/4 inch nipple at the top of the tank. Then ...

...air compressor and hook the air line to an open hot tap and put pressure and run the water out another hot tap. Close all taps but these two and make sure the cold water inlet to the tank is shut

...cold side {blue on the heater} the hot side to the red, take the cover plate off on the water heater run the wires, hook up the groung wire then the red and white wires to the wires comming off the ...

...cold water line. You will want to open at least a few faucets, to purge out the air, don't open all the way for they will sputter and make a mess. After you have gotten out most if not all of the ...

...cold air retuned nothing plugged any ideas http://www.hearth.com/talk/categories/main-hearth-forums.4/ You burn wood, and smoke goes up flueway. You're not running chimney smoke through ductwork so ...

...cold water supply 2. Hook a water hose to the boiler valve (spicket on the bottom of the tank) and turn on the valve 3. Turn on the cold water inlet line and let it run for about 15 minutes or until ...